Fassatherm®DNA: new materials and accessories
The starting point for the birth of this new solution was the study of new products capable of providing the system with the desired robustness. It therefore started with two new plasters: Fassa DNA HPa Mineral hydraulic plaster with high mechanical performance for the installation of modular rigid coatings e Fassa DNA lighta lightened hydraulic plaster Suitable for a wide range of finishes.
These two new plasters, to be chosen according to the privileged finish, go to adhere on the traditional base of the thermal coatcomposed of glue and insulating panel, With a new bidirectional reeling reeling in alkali-resistant fassanet DNA 450 fiberglass, Fassa Top Fix 2G Tasselli to screwing for the fixing of insulating slabs in ETICS systemsand above all Fassa Rond 170a three -thick special plastic sparkle washer. This combination, the result of the Studio del Fassa I-Laballows you to distribute a thick layer of plaster, on which to then proceed with the finishes.
More freedom in the choice of finishing
This strongly strengthened structure is suitable for support any type of coatingeven heavy, leaving maximum freedom to the creativity of the designer: from ceramic to stone, from plaster to extremely smooth finishes, from the elegant decorative effects to the use of saturated tones (also the dark colors, normally not recommended), up to the classic coatings with natural and breathable materials.
More protection and resistance
The high mechanical resistance of the system significantly increases surface robustness: fassatherm®dna It resists better for strong stresses, accidental impacts and shocks due to atmospheric eventssuch as hail, Compared to a traditional coat system.
Best Thermal Boarding and Minor Superficial Condenses
With the same thermal capacity, the mass of the plasters of the Fassa DNA line allows delay the entrance of the heat inside the housing spacesreducing the need to refresh the internal environments.
Furthermore, according to the climatic and environmental conditions, The mass and thermal capacity of the plaster applied 25 mm thick allow you to have minor outdoor surface condensation compared to a traditional coat system. This means significantly reducing the possibility that algae and molds are formed in isolated facades externally.
Fassatherm®dna marks a turning point in external thermal insulation systemsunwriting Energy efficiency, durability and maximum design flexibility: An answer to the challenges of modern construction in a product that collects and enhances all the experience and know-how of Fassa Bortolo.
For more information
fassabortolo.it
